home > Industries > Compounds > ASTM B527 Metallic Powders and Compounds Tap Density Apparatus 301-8.
ASTM B527 Metallic Powders and Compounds Tap Density Apparatus 301-8.
ASTM B527 Metallic Powders and Compounds Tap Density Apparatus
LABULK 0335 Intelligent Tap Density Tester P/N 33598
are manufactured according to international standard ASTM B527 Standard Test Method for Determination of Tap Density of Metallic Powders and Compounds.
LABULK 0335 Tap Density Testers
Scope
This test method specifies a method for the determination of tap density (packed density) of metallic powders and compounds, that is, the density of a powder that has been tapped, to settle contents, in a container under specified conditions.
Referenced Documents
ASTM B 215 Practices for Sampling Metal Powders
Significance and Use
This test method covers the evaluation of the tapped density physical characteristic of metallic powders and compounds. The degree of correlation between the results of this test method and the quality of powders in use will vary with each particular application and has not been fully determined.
Associated Apparatus
-Balance
-Graduated glass cylinder
-Tapping apparatus
Test Specimen
(Please see standard)
Procedure
(Please see standard)
Calculation
(Please see standard)
Report
(Please see standard)
Precision and Bias
(Please see standard)
ASTMB527-Metallic-Powders and-Compounds-Tap-Density-Apparatus
Tap density tester https://www.labulk.com
Leave a Reply
- Links:
Good morning,
could you please send me a quotation about your LABULK 0335 Tap Density Tester unit in accordance to ASTM B527? I would need it to be able to comply with both a 25mL and 100mL cylinder.
Thank you and Best Regards.
Maria Bertoldi
Good morning,
I’m here to ask a quotation about your LABULK 0335 Tap Density Tester unit in accordance to ASTM B527. I would need it to be able to comply with both a 25mL and 100mL cylinder.
We are an Additive Manifacturing company and we are based in Italy
Thank you and Best Regards.
Alessandra Speroni
Good Afternoon,
I hope all is well. I was inquiring if you could provide me with a quote for a LABULK 0335 Tap Density Tester unit. I would need it to comply with a 25mL and 100 mL cylinder, in accordance with ASTM B257. If you have any questions, please do not hesitate to contact me, thank you.
Best Regards,
Sierra Barner
WMT&R
724-537-3131
Good Afternoon,
I hope all is well. I was inquiring for a quote on a LABULK 0335 Tap Density Tester unit. I would need it to be able to comply with both a 25mL and 100mL cylinder, in accordance with ASTM B527. Please let me know if you have any questions, thank you!
Best Regards,
Sierra Barner
Chemical/Project Engineer
WMT&R