1. Labulk-0307 Plastic Materials Apparent Density Tester, Bulk Factor Tester and Pourability Tester Manual – Installation

Date: 2016-04-26 / Author: labulkcomadmin / Category: Labulk-0307 Manual

Assemble the apparatus as picture below, put the measuring cup in the axis of the funnel orifice.
Adjust the stand screws and make the bubble in center to level the instrument.
Put the height control (38 mm) between the funnel orifice and the measuring cup, then fix the pivoting ring arm and remove the height control.
Close the small end of the funnel with the flat strip, now the installation is finished.

1-labulk-0307-plastic-materials-apparent-density-tester-bulk-factor-tester-and-pourability-tester-manual-installation

1-labulk-0307-plastic-materials-apparent-density-tester-bulk-factor-tester-and-pourability-tester-manual-installation

Prev: 2. Labulk-0307 Plastic Materials Apparent Density Tester, Bulk Factor Tester and Pourability Tester Manual – Test Procedure – Apparent Density
Next: Photovoltaic industry drives rapid development of air jet sieve

Leave a Reply