Bulk Density


ISO3953 Metallic Powders Tap Density Tester

ISO3953 Metallic Powders Tap Density Tester(CAT.NO.030198/CAT.NO.032798/CAT.NO.032698) is manufactured stringently according to international standard ISO 3953 Metallic Powders – Determination of Tap Density.

Scope
This international standard specifies a method for the determination of tap density, i.e. the density of a powder that has been tapped into a container under specified conditions.

Principle
A specified amount of powder in a container is tapped by means of a tapping apparatus until no further decrease in the volume of the powder takes place. The mass of the powder divided by its volume after the test gives its tap density.

Symbols
(Please see standard)

Apparatus
-Balance
-Graduated glass cylinder
-Tapping apparatus

Sampling
(Please see standard)

Procedure
(Please see standard)

Expression of results
(Please see standard)

Test report
(Please see standard)

ISO3953-Metallic-Powders-Tap-Density-Tester

ISO3953-Metallic-Powders-Tap-Density-Tester

Leave a Reply